Cutpoint Engineering
Interactive Tools Dilution Cost

Dilution Cost
Calculator

Model fluid dilution costs, evaluate SREE equipment advantages, and audit LGS concentrations in real time.

Dilution Cost Calculator

Solids Control & Mud Management

Well Setup Parameters

Base Parameter Benchmarks

Simulated Parameters (Sliders)

Simulated SRE (Separator Efficiency) 70%
Simulated Target LGS Concentration 4%
Rate of Penetration (ft/hr) 50
Base Dilution Cost $0.00 At Base Benchmarks
Simulated Cost $0.00 At Slider Settings
Cost Savings with new parameters $0.00 No Parameter Change
Gauge Hole Volume 0.00 bbl
Sim. Solids Influx 0.00 bbl
Sim. Dilution Mud 0.00 bbl
Drilling Time 0.00 hrs
Sim. Dilution Rate 0.00 bbl/hr
Sim. Solids Influx Rate 0.00 bbl/hr

About Dilution

Accumulation of Low Gravity Solids (LGS) increases mud viscosity and wear on drill bits. When solids control equipment (SCE) cannot remove these fine particles, clean mud must be added to dilute the solids concentration back to target parameters.

Handbook Mandates:

  • Hole Volume (V_hole):
    V_hole = (Interval * Diameter^2) / 1029.4
  • Solids Influx (V_lgs_in_mud):
    V_lgs = V_hole * (1 - SREE/100)
  • Dilution Factor (V_dil_factor):
    Dilution Factor = (100 - LGS%) / LGS%
  • Total Mud built:
    Total Dilution = V_lgs * Dilution Factor

The SREE Advantage

Increasing your **Solids Removal Efficiency (SRE)** by just **10%** significantly reduces the volume of solids that get entrained in the active mud. This decreases both dilution mud demand and disposal volume, leading to massive well cost savings.